for more information about Jaro Thermal's cooling technology.
| |
|
|
 |
Aavid’s Stampings for LED
footprints up to 34 x 34mm
Features & Benefits
• Lightweight
• Variety of fin configurations
• Low Cost
• Requires minimal structural support
• Use with natural or forced convection
airflow
• Can support high volume production
|
Aavid’s Pin
Fin for LED footprints up to 40 x
40mm
Features & Benefits
• Fin array allows airflow in any
direction
• Compact size
• Available with pre-applied thermal
tape
• Excellent forced convection cooling
• Reduced space requirement
• Simple assembly
• Cost effective
|
 |
 |
Aavid’s Extrusions for LED
footprints 40mm and above
Features & Benefits
• Highly configurable
• Low Thermal Resistance
• Can incorporate structural and aesthetic
elements
• Cools multiple devices
|
|
Light Emitting
Diodes (LEDs) have been around
for years, primarily concentrated
in such markets as cell phones, PDAs
and other consumer electronics. Today,
as technological advancements in LED
design and processes are continually
boosting light output to rival incandescent,
fluorescent, and even halogen light
sources, the need to protect the LEDs
against heat build-up is greater than
ever before.
|
 |
 |
Bond-Ply®
Adhesive
Bond-Ply is a thermally conductive,
pressure sensitive adhesive tape,
available in either fiberglass reinforced
or unreinforced. With its ability
to have high bond strength, it can
eliminate the need for screws, clip
mounts or fasteners.
• Good thermal performance
• Immediately bonds to target surface
• Eliminates need for mechanical
fasteners or screws
• Alternative to heat-cure adhesives
|
Liqui-Bond®
Adhesive
Liqui-Bond is a thermally conductive
liquid silicone adhesive that cures
to a solid bonding elastomer. Liqui-Bond
features excellent low and high-temperature
mechanical and chemical stability.
It can be supplied in either a tube
or mid-sized container form.
• High thermal conductivity
• Easy dispensing
• Can achieve a very thin bond line
• Heat cure
|
 |
